Private well owners are responsible for the quality of their drinking water. The U.S. Environmental Protection Agency (EPA) does not regulate private wells. Homeowners with private wells are generally not required to test their drinking water, although local Boards of Health or mortgage lenders may require well water testing. While there is also no state requirement to have your well water tested, the Massachusetts Department of Environmental Protection (MassDEP) recommends that all homeowners with private wells do so, and use a state certified testing laboratory. Refer to the fact sheet Drinking Water Standards for more information. Show The Secondary Maximum Contaminant Level (SMCL) for pH is 6.5 to 8.5 on the pH scale as established by the EPA.
SummarypH is an indicator of the acid or alkaline condition of water. !e pH scale ranges from 0-14; 7 indicates the theoretical neutral point. Water with a pH value less than 7 indicates acidity and tends to be corrosive, while water with a value greater than 7 indicates alkalinity and tends to affect the taste of the water. Acidity or low pH of drinking water is usually a result of natural geological conditions at the site, possibly compounded by acid rain. Testing for the pH of your well water is crucial for:
Home treatment methods to adjust pH include neutralizing filters and neutralizing solutions (soda ash). Potential Health EffectsThe pH of drinking water is not a health concern, however, acidic water (low pH) can leach metals from plumbing systems, which can cause health problems. Indications of Low pHSymptoms of low pH are bluish green stains on fixtures with copper plumbing; reddish stains with galvanized iron plumbing; and water system corrosion problems and plumbing leaks. SourcesIn most locations, well water in Massachusetts is naturally acidic due to the surrounding soils and bedrock. Testing for pH in Private Drinking Water WellsTo determine the pH, arrange to test your drinking water at a state certified laboratory. Follow laboratory instructions carefully to avoid contamination and to obtain a good sample. Home test kits may not provide accurate results. Determining pH is often essential in evaluating the presence and effective treatment of other drinking water contaminants, such as:
Corrective ActionsNeutralizing FilterIf your water is acidic (low pH), you can use a neutralizing filter containing calcite or ground limestone (calcium carbonate) or magnesia (magnesium oxide) to raise the pH. Neutralizing filters must be backwashed periodically since they serve as mechanical filters to remove solid particles from the water. !ey also require periodic replenishment of the neutralizing material within the filter bed. When acidic water is treated with a neutralizing filter such as ground limestone (calcium carbonate), hardness is added to the water. This happens as a result of adding calcium and magnesium minerals that the water absorbs when passing through the filter. This is also why the neutralizing materials need periodic replenishment. Installing a cartridge filter prior to the neutralizing filter will remove solid particles from the water and can help to prolong the life of the neutralizing filter. Arrange to test your water for hardness after installation of a neutralizing filter. Levels up to 120 milligrams per liter of calcium and magnesium are acceptable, however, at levels between 120 milligrams per liter and 180 milligrams per liter, the user may prefer to soften the water, or remove some of the calcium and magnesium. If either calcium or magnesium is present in your water in substantial amounts, the water is said to be “hard,” because making a lather or suds for washing is “hard” (difficult) to do. Water containing little calcium or magnesium is called “soft” water. Ion exchange treatment can be used to treat “hard” water. It is also commonly used in Massachusetts to remove iron and manganese. Refer to the fact sheet Ion Exchange Treatment of Drinking Water for more information. Neutralizing SolutionsFor high yield water supplies, an alternate method of neutralizing acidic water is to feed a solution of soda ash to the water supply with a chemical feed pump. Sodium carbonate can raise the pH level to 8 or higher. Where water contains a lot of iron, or if you need to disinfect the water, a chemical feed pump is often used since hypochlorite bleach and soda ash may be mixed in a single solution and fed into the water system with the same pump unit. Potassium can be substituted for sodium if necessary. Like sodium, the potassium substitute should be evaluated for any possible human health effects. Too much potassium can cause nausea, diarrhea, muscle weakness, and even cardiac arrest. When choosing a treatment method, consider both the initial cost and the operating costs. Operating costs include the energy needed to operate the system, additional water that may be needed for flushing the system, consumable supplies and filters, repairs, and general maintenance. Regardless of the quality of the equipment you purchased, it will not operate well unless maintained in accordance with the manufacturer’s recommendations. Keep a logbook to record equipment maintenance and repairs. Equipment maintenance may include periodic cleaning and replacement of some components. Also consider any special installation requirements that may add to the equipment cost. See the fact sheet Questions to Ask When Purchasing Water Treatment Equipment for more information. Protection of Private Drinking Water SuppliesYou can protect your private well by paying careful attention to what you do in and around your home as well as your neighbor’s activities near your well. Regular testing and adopting practices to prevent contamination can help ensure that your well supplies you and your family with good quality drinking water. For more information on well protection see the fact sheet Drinking Water Wells. ResourcesCenter for Agriculture Food and the Environment This fact sheet is one in a series on drinking water wells, testing, protection, common contaminants, and home water treatment methods available on-line MA Dept. of Environmental Protection, Division of Environmental Analysis Offers assistance, information on testing and state certified laboratories: 617-292-5770 For a listing of MassDEP certified private laboratories in Massachusetts U.S. Environmental Protection Agency, New England Office US Environmental Protection Agency For a complete list of primary and secondary drinking water standards MA Department of Conservation and Recreation, Division of Water Supply Protection NSF International The NSF International has tested and certified treatment systems since 1965. For information on water treatment systems: 800-NSF-MARK Water Quality Association The Water Quality Association is a not-for-profit international trade association representing the household, commercial, industrial, and small community water treatment industry. |